Grooming Rake

Description

Grooming Rake

Grooming Rakes are designed to pull out dead coat and shedding fur with ease. Typically they are a T-shape with rounded pins on the head of the T. On some heads, the top bar is long, up to 6 inches across. On other designs, the head may be only a couple of inches wide. The length and shape of the teeth will vary, too. On some rakes the teeth are short and shaped almost in a tiny cone-type fashion. With others, the teeth are long, sinking deeply into heavy, long coats. On almost all models, the handle comes directly out from the cross bar head with all the teeth.
This type of rake is designed to remove dead coat while not damaging the healthy coat. You work the tool in the natural direction of the coat growth. Care must be used not to sink the comb too far into a dense coat repeatedly with too much pressure. Tugging too firmly on a thick or tangled coat will be uncomfortable for the dog and difficult for the groomer. Repeatedly digging in too deeply could injure the skin, as well

Things to remember while using grooming rakes:

• A clean coat is going to facilitate speed in the grooming process. Let’s face it, it’s much more enjoyable to work on a clean coat versus a dirty coat! Let the shampoo do a lot of the work for you. If you remove the dirt prior to doing a lot of brushing, your products and your tools can do most of the work for you to remove matted and shedding coat. My rule of thumb is if the water can penetrate to the skin, get the dog directly to the tub. If there are sections that are so dense that water can’t penetrate, cut those areas into sections so that it can. Do at least two lathers with a shampoo.
  The first one can be quick and the second lather much more thorough. Occasionally, you might need a third lather in certain spots to get it clean. Using a great conditioning treatment after the bathing process can also be very beneficial.
• A powerful high velocity dryer or “blaster” is the key to getting through this type of grooming job. A powerful stream of air from the high velocity dryer will do the bulk of the work for you when it comes to removing mats, tangles, and shedding coat.
  Ideally, you will want to have a condenser cone on the nozzle of the dryer when you first start the drying process. On well-behaved dogs who enjoy the high velocity dryer, two or even three high velocity dryers can be used to speed up the entire process.
  On pets that have a lot of mats, tangles, and densely packed coat, using a high velocity dryer with a condensing nozzle to blow the shampoo out of the coat on the second lather in the tub is a great trick. What do you do when you have a ring on your finger that you can’t get off? Apply soap, right? The same principle applies. The shampoo provides the lubrication and air pushes the hair apart. Easy on the dog – and easy on you.

Similar products from amazon